For some calls in (such as some IMS emergency calls) you’ll get MIME Multipart Media Encapsulation as the SIP body, as the content-type set to:

Content-Type: multipart/mixed;boundary=968f194ab800ab27

If you’re used to dealing with SIP, you’d expect to see:

Content-Type: application/sdp

This Content-Type multipart/mixed;boundary is totally valid in SIP, in fact RFC 5261 (Message Body Handling in the Session Initiation Protocol (SIP)) details the use of MIME in SIP, and the Geolocation extension uses this, as we see below from a 911 call example.

But while this extension is standardised, and having your SIP Body containing multipart MIME is legal, not everything supports this, including the FreeSWITCH bridge module, which just appends a new SDP body into the Mime Multipart

Okay, so how do we replace the MIME Multipart SIP body with a standard SDP?

Well, with Kamalio’s SDP Ops Module, it’s fairly easy:

#If the body is multipart then strip it and replace with a single part
if (has_body("multipart/mixed")) {
	xlog("This has a multipart body");
	if (filter_body("application/sdp")) {
		remove_hf("Content-Type");
		append_hf("Content-Type: application/sdp\r\n");
	} else {
		xlog("Body part application/sdp not found\n");
		}
}

I’ve written about using SDPops to modify SDP before.

And with that we’ll take an SIP message like the one shown on the left, and when relayed, end up with the message on the right:

Simple fix, but saved me having to fix the fault in FreeSWITCH.